Completely Reconditioned ACME Bench Dough Rollers

Call: Ray or Jackie
(701)227-3396

AAA Reconditioning will fully recondition your ACME Dough Roller models 11, R11 and MR 11 bench sheeters to a like new status. We are so sure of the quality of our work that we guarantee it for 90 days (under normal operating conditions). For your convenience we pickup and deliver, that means no downtime, no crating or uncrating and you save money on freight! We also buy old units not in use.

AAA Reconditioning does business nationwide, so trust us for your reconditioning needs!

New Featured Services

Call for additional manufacturing of other parts.

Bench Dough Rollers Models (Model-11 Coveyor/Slide, R-11, MR-11 & MRS-11)

All are two-stage machines with both a front infeed and front discharge for efficient operation. Cleaning is quick, easy and safe.

Can roll dough up to 18" or 24" in diameter (depending on model). It is ideal for pizza, pie crusts, Arabic bread, flour tortillas, wraps, and many other doughs.

Reconditioning of the ACME dough roller models 11, R11, MR 11 and MRS 11.

Reconditioning shall consist of the following:

1. Disassemble dough roller and all of the components.
2. The following are stripped to bare metal: dough roller frame roller shafts scraper blade holders idler arm assemblies belt alignment collars and brackets shaft castings belt adjustment rods power drive guard assembly top and back cover electrical boxes
3. The rollers are turned and polished, after which a coat of food grade lubricant is applied.
4. The hopper, feed pan and all stainless steel parts are cleanded and polished then a coat of food grade lubricant is applied.
5. The gear reducer is cleaned and serviced. The following parts are also serviced: pulley change gear lube replace seals check for worn shaft and gears
6. The drive moter is cleaned and serviced, which includes the following: replace brushes replace broken wiring and terminals replace bearings replace service cord check service cord check shaft, armature and bushings
7. The plastic or metal scraper blades are replaced.
8. Drill and re-tap adjustment knob holes if stripped.
9. Drill holes for mounting the easy set roller thickness adjustment cranks.
10. Gear and motor supports are welded which adds extra support.
11. The following are replaced with new parts: roller bearings drive chain assembly conveyor and motor drive belts springs on idler arm and scraper blades roller adjustment knobs stripped or broken bolts, pins and screws stud shaft and lower idler arm roller shafts lower and upper idler sprockets and shaft belt alignment collars feed pan
12. A base coat of primer is applied, after which follows a finish with epoxy enamel seal on the following parts: frame idler and assemblies shaft castings ends of upper rollers take up rods dust cover: top and back cover stud shaft all sprockets
13. Finally, the plate containing serial number and model number is attached on the frame.

All reconditioned will also have the new easy set roller thickness adjustment cranks installed FREE of charge!